Hard edge flexible back carbon bandsaw blades for small, light duty machines with occasional use. Use in tool rooms and general maintenance areas. One-piece construction with teeth hardened to Rc 64-67. Back hardness is Rc 28-35. Fatigue resistant even at high speeds. Low cost and good wear resistance. General purpose cutting of mild steels and nonferrous metals; also use on wood, plastic, cork, fiberglass, graphite, aluminum, brass, bronze, cast iron, copper; lead and zinc. Notes on ordering: Blades welded to length. In checkout, please indicate in Comments box exact length required and teeth per inch. For blades a fraction over the foot in length, figure as the next half foot. (Blades available from 5 feet, 6 inches, to 20 feet.) Raker set blade will be shipped unless otherwise specified. Other available types are standard wavy set, skip tooth and hook tooth raker. Blades are a special order item and are nonreturnable (unless defective), so please verify size!
Warning:This product may expose you to chemicals including Nickel, Chromium, or Lead, chemicals known to the State of California to cause Birth Defects and/or Cancer. For more information go to www.P65Warnings.ca.gov